so for whatever reason the xlights upload output command is not updating the co-bbbString.json file in the /media/config directory.
I checked the xlights log and it shows the new json file with all my config and that the upload is successful but when i check the file on the BBB it's still the...
Followed all your instructions and even tried to remove the co-bbbString.json file.
No luck again, even formatted the micro sd card and did a fresh install of a the 7.1 release to see if that would make a difference.
Could it be something buggy that happend when i applied my my falcon licence...
Definitely saving, the upload output and get the following msg in xlights.
And I can see the fppd restarting via the web gui.
it's just not reflecting in the gui ui still for some silly reason.
Hi All,
Running a halloween light show for year #3 now and just got my HE123 MKII up and running to replace another controller box.
I have my project setup in xlights and trying to upload the output for the channels I've configured for all my props and noticed that fpp channel output doesn't...
See the diagram below, pretty much extending the power injection cable after the 1st power injection to allow for a second power injection using the same two wires.
I'm just trying to find a non fiddly way to do this without having to buy power injection tees or spending too much time soldering...
Howdy all,
I've been using 3-2-3 power injection tees for the last two seasons and in most cases have a single power injection of any one port on my controllers, I've made a few poor attempts to Y/T splice an additional power injection of the existing 2 core cable and haven't been overly happy...
Talk about fast delivery @AAH, just received my HE123 mk2.
Wil have a play around and be adding the HE123-TX and and a few HE123-RX'2's in the near future.
Thanks @AAH, I'm currently sitting at around 2700 pixels in my current show after two seasons of blinky's so still have a way to go until I get even close to 8,000 pixels.
Howdy all,
Now that the blinky season is over just doing some planning for 2023 and looking at purchasing new gear to play with.
One of the questions that popped into my head is the max safe wattage you should be able to get from a standard 240V power point in Austalia.
From what I've read...