Recent content by KHill9314

A new sequence for our 2023 show. Sequenced by myself!

A new sequence for our 2023 show. Sequenced by myself!

A crowd favourite! Sequence by EFL Sequences!

A new sequence for our 2023 show. Sequenced by myself!

A returning sequence from 2022, Sequenced by myself!

I used one of these for my main controller, worked really well. Using a sheet metal holesaw meant I had no issues with chipping etc. Can't speak for its waterproofing as I had it under a makeshift shelter but it worked well for keeping vermin/bugs out etc.

I've found the Hanson Electronics gear to be great for my first year last year. Pretty affordable compared to other options and really accessible with room to expand in the future.

Thanks for the response, I have always just opened the files straight from the show folder on the drive. I have had an instance before where the drive letter had changed. But it was as simple as reselecting the show folder on initial start up on that occasion. I did notice through fault finding...

Hi all, Currently trying to load my sequences on my laptop (I use a desktop for the majority of sequencing, show folders on portable hard drive to swap between the two). I am getting an error when trying to open the sequences, Unable to load sequence and references the FSEQ file specifically...

I didn't get any photos sorry, topper was an end off of a plastic cable drum with eye bolts, had to make a uhmw adapted so it could fit on the PVC. No base on mine, I just marked a 1500 diameter circle on the grass and used screw anchors to tether the strings to. Did the job but will look at a...

I had a tree with similar specs to that last year, I got away with a larger diameter PVC pipe as the "trunk" of my tree sitting over a tall star picket that was driven into the ground. With some guy lines from the tree topper down, it was solid as a rock.

Not the starting location?

Depends on what effect your going for. The air seeder pipe is good for the diffused look but is ridiculously expensive if you have to ship it. Myself, I just made a PVC base similar to others air seeder builds, but used regular old poly pipe and cable tied the pixels to the top (Couple of small...

Thanks guys, appreciate the responses 👍 Yeah just wasn't sure about any 12v to 5v conversion so thanks for clearing it up for me 🤙

Just chasing some info from any fellow HE123 owners and users. Planning on powering my HE123 with the same 12v PSU powering some smaller props of mine. After doing some reading of the manual and prodding around the boards, the conclusion I'm coming to is that due to using the 12v for the HE123...