Facebook
youtube
Home
What's new
New posts
New display videos
New media
New media comments
Latest activity
Forums
New posts
Search forums
Wiki
Search wiki pages
Media
New media
New comments
Search media
Display videos
New display videos
Search display videos
Display locations
Displays by region
Members
Current visitors
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
Current visitors
Latest activity
Menu
Log in
Register
Navigation
Install the app
Install
More options
Close Menu
Home
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Notenoughlights's latest activity
Notenoughlights
replied to the thread
Noob. Need AC replacement for solar for 1000 LED 100m Lytworx
.
unlikely, as you can't "push" current into something, it will only draw what is available. Increasing the voltage will probably brighten...
May 1, 2024
Notenoughlights
replied to the thread
Mark's seed pixel mega tree - Smaller and cheaper!
.
They appear to be a standard clipsal/bunnings seta 2 way 20mm box. Typical type found in electrical installations nz/aus wide. Commonly...
Apr 29, 2024
Notenoughlights
replied to the thread
Laptop vs ???
.
Using an esp32 router or portable router and wled, could result in a very easy and cheap controller setup with the added bonus of wled...
Apr 27, 2024
Notenoughlights
replied to the thread
Laptop vs ???
.
I installed fpp on a Pi Zero, just for a laugh to see if it would work for my show, and to no surprise it struggles a little but for a...
Apr 27, 2024
Notenoughlights
reacted to
AAH's post
in the thread
Updated catalogue and lots of new stuff
with
Like
.
The latest catalogue is kinda ready in draft form here...
Apr 25, 2024
Notenoughlights
reacted to
AAH's post
in the thread
Updated catalogue and lots of new stuff
with
Like
.
I added a few more boards today. 2 "dumb" differential boards for direct connection to the brick style power supplies. The 2 boards are...
Apr 25, 2024
Notenoughlights
reacted to
AAH's post
in the thread
HE123 MK2 No power
with
Like
.
Changeover on the way. Definitely sounds like the protection diode went short which is what it's meant to do when there is a fault.
Apr 21, 2024
Notenoughlights
replied to the thread
HE123 MK2 No power
.
@AAH may be best to advise here as well. I would perhaps send him a private message, or use his contact-us link on his website if you...
Apr 21, 2024
Notenoughlights
replied to the thread
HE123 MK2 No power
.
That sounds like the diode is shorted so it's conducting in both directions. Was your wiring reversed at any stage? The diode should not...
Apr 21, 2024
Notenoughlights
replied to the thread
HE123 MK2 No power
.
What do you mean by correct voltage both sides? Test with the power off on the meters diode setting, probes one way should read 0.6...
Apr 21, 2024
Notenoughlights
replied to the thread
HE123 MK2 No power
.
Do either of the 2 yellow things beside the power wires (Thermal fuses) get hot when powering the board on? Do you have a multimeter on...
Apr 21, 2024
Notenoughlights
replied to the thread
HE123 MK2 No power
.
Can you post a photo of how it's all wired up?
Apr 21, 2024
Notenoughlights
replied to the thread
Another power injection question
.
Check the pinouts on your connectors match, I had a batch of those in use, then purchased another bundle, and the plugs were wired...
Apr 18, 2024
Notenoughlights
reacted to
Johnnyboy's post
in the thread
Controller Wiring - Using Power Bus line
with
Like
.
Good call on the fuses, very important. Fuses will be used at each branch off points
Apr 12, 2024
Notenoughlights
replied to the thread
Controller Wiring - Using Power Bus line
.
You'll want to put fuses on all those lines going to the pixels, usually the intention of the fuses on board the controller.
Apr 12, 2024
Home
Members
Top