I've had to rebuild my Pi Player after SD card died.
Using the latest version 7.2 on a Pi 4
Issue I'm having is that FPP is not sending blanking info to the ESP controllers which, then go into test mode after a while when they don't receive any input (E1.31)
I've ticked "Blank between sequences"
I can see the lights turn off for a few seconds when rebooting the Pi / or when I send a lights off command from FPP
Everything else is workingfine - only change I was using older version 6?
Question, is there a magic setting some where to continuously send blanking info to the controllers?
Using the latest version 7.2 on a Pi 4
Issue I'm having is that FPP is not sending blanking info to the ESP controllers which, then go into test mode after a while when they don't receive any input (E1.31)
I've ticked "Blank between sequences"
I can see the lights turn off for a few seconds when rebooting the Pi / or when I send a lights off command from FPP
Everything else is workingfine - only change I was using older version 6?
Question, is there a magic setting some where to continuously send blanking info to the controllers?