prontoheal
New elf
- Joined
- Dec 30, 2013
- Messages
- 11
Hi everyone I know what type of crazy person am I throwing out lights mid December, but here I am. So this morning I found a Pixcon16 sitting around in the garage an dI thought to myself I can set this up today. My current setup is full LOR with no DMX.
So after watching some videos I configured the Pixcon16 to an IP address and and assigned it to a DMX universe. I also set upthe lights to have 50 pixels per output. When I tested the lights I could see all of the lights turn on.
I then ensured the controler was using 16 universes. placed it into my LOR software no problems, but when I set my sequences to it the first string full lights up and then half og the next string will light up then for the next string the other half will light up right up to pnly a couple of lights working for the string.
I am just wondering did I set the pixels per output to low for the output? or something else.
Apart from this I had no problems incorpating DMX into my LOR lights show.
Thanks
So after watching some videos I configured the Pixcon16 to an IP address and and assigned it to a DMX universe. I also set upthe lights to have 50 pixels per output. When I tested the lights I could see all of the lights turn on.
I then ensured the controler was using 16 universes. placed it into my LOR software no problems, but when I set my sequences to it the first string full lights up and then half og the next string will light up then for the next string the other half will light up right up to pnly a couple of lights working for the string.
I am just wondering did I set the pixels per output to low for the output? or something else.
Apart from this I had no problems incorpating DMX into my LOR lights show.
Thanks