Dez
Fueled by Christmas - Inspired by You!
- Thread starter
- #16
Any chance you could do a video on this? My screen looks different to yours.To automate FPP shutdown, I have a scheduled playlist that triggers an event to run the FPP shutdown script:
- go to Content Setup > Script Repository Browser
- scroll down to Category: "System" Filename: "Shutdown.sh" and click the 'install' button
- Create a new event, go to Status/Control > Events
- Choose an available event id (next unused one?), give it a name, command is "Run Script", script name "Shutdown.sh":
- View attachment 14888
- Add a new Playlist (the event ID below is different to the example above as I had already created this event, your event id will be the same)
- View attachment 14889
- playlist should look like this after it is added:
- View attachment 14890
- (you would be able to add this event this as a leadout from your show playlist also, noting that it would run immediately after your show)
- Add this playlist to your schedule, I run mine 15 minutes after my show ends:
- View attachment 14891
I have a DIN pool pump timer infront of my power supplies, FPP, Falcon and switch: https://www.edaonline.com.au/produc...ctrical-24-hour-electricians-tools-pool-pump/
This is rated to 16 amps, I only have a small display and Im pulling less than 2amps AC, so well within the timers spec. Get your sparky to wire this up ;-)
So the pool pump timer will power everything up around 6pm, and then the FPP will shutdown cleanly at 23:15 followed by the pool pump timer switching everything off at 23:30.
Works a treat.
Steve