Ok so I have connected a dmx2-24 for 28v supply (until my 31v psu arrives )
And I have connected the first 50m string of lights to connector cables 1-2 ( this should be the first cable set )
Now in da-tester
They work fine
Full control
if i go into x-lights - it won’t see it as a auto discovery controller - I have to manually set it as USB
Serial com 7 dmx
When I activate it / it’s gets the greennoght showing it sees something
Test mode in x-lights - does nothing - they stay dead
back to the tester software and works still
What did i do wrong on the usb setup ?
And I have connected the first 50m string of lights to connector cables 1-2 ( this should be the first cable set )
Now in da-tester
They work fine
Full control
if i go into x-lights - it won’t see it as a auto discovery controller - I have to manually set it as USB
Serial com 7 dmx
When I activate it / it’s gets the greennoght showing it sees something
Test mode in x-lights - does nothing - they stay dead
back to the tester software and works still
What did i do wrong on the usb setup ?